… After confirming the successful fabrication of NIR light-triggered flexible DDS by TEM,
SEM, AFM, photoluminescence, UV–vis spectroscopy and current density–voltage (J–V) …

A methodology for optimal volume computation for the environmental management of waste
stockpiles was derived by integrating the terrestrial laser scanning (TLS) and unmanned …

… The D* calculation using EQE and J D values … J ph and inversely proportional to J D 0.5 ;
thus, this device also showed a large D* >10 12 Jones at a reverse 3 V bias because the J ph /J …

Low dimensional (LD) perovskite materials generally exhibit superior chemical stability against
ambient moisture and thermal stress than that of 3D perovskites. Recently, LD perovskite …

… However, this condition decreases the J SC because of the … This trade–off relationship
between the V OC and J SC has … OC and J SC and improve the V OC while maintaining the J SC , …

I. Nomenclature α, AoA= angle of attack ρ = raw pixel density ρ= pixel density c= chord length
Cl= sectional lift coefficient CFD= computational fluid dynamics CNN= convolutinal neural …

Electrical doping is essentially required for high‐performance organic thermoelectric (TE)
materials; however, the doping efficiency η d has not been extensively investigated in highly …

… mV, a J sc of 14.3 mA cm –2 , and a FF of 64.0%); Figure 1c displays the current density (J)–voltage
(… extracted from the J–V curves are summarized in Table 1 (PCE = P out /P in = (V oc ·…

Chemical doping can be used to tune the optoelectronic properties of conjugated polymers (CPs),
extending their applications as conducting materials. Unfortunately, chemically doped …

… \(\nabla _{x}J\) of a cost function J with respect to its design variables x to guide the search
towards a global optimum. For airfoil shape optimization, the cost function J can be a metric of …